Panasonic SF4B-F31G(V2) Instruction Manual page 44

Interlock function
External device monitor function Valid
Auxiliary output
The device output is selected depending on the connecting state of the output polarity setting wire
(shield).
Incorrect wiring may cause the lockout state.
* Symbols
Switch S1
Vs to Vs - 2.5V (sink current 5mA or less): Emission halt (Note 2), Open: Emission
K1, K2: External device (Forced guided relay or magnetic contactor)
Notes: 1) If the interference prevention wire is extended, use a 0.2mm
2) Vs is the applying supply voltage.
3) For resetting, refer to "3-2 Interlock Function."
44
Valid (Manual reset)
Can be used
2
or more, shielded twisted pair cable.
© Panasonic Industrial Devices SUNX Co., Ltd. 2017