Front Ethernet Module Installation; Riser Card Installation (Optional) - Lanner FW-8759 User Manual

Front Ethernet Module Installation

The FW-8759 can accommondate Lanner NCS2 type Fiber
or RJ45 Ethernet expansion modules.
1. To install the front Ethernet module, take off the front
bezel first by unfastening the thumbscrews on the
front of bezel.
2. Insert the Ethernet module into the front expansion
slot. You should hear a click when the module
connects to the riser card.
3. Secure the Ethernet module by fastening the
thumbscrews on the module. (Using a screw driver is
highly recommended.)

Riser Card Installation (optional)

The FW-8759 provides one PCIex8 (Generation 3) slot
for installing the riser card for rear expansion capability.
Follow this procedure bellow for installing a riser card.
For rear expansion riser card installation, order Riser
Card kit RC-87592A and use the following procedure:
1. Align the divider of the riser card RC-87592A with the
slot key on the socket.
2. Press the card to insert the card into the socket until
it installs firmly. Secure the card with 3 screws (two on
the bottom through the chassis).
3. Connect the expansion card to the riser and
4. Attach the slot cover on the back of the chassis.