Front Panel Features - Lanner FW-6436 User Manual

Chapter 1

Front Panel Features

F1 F2 F3
F1 ATX Power Switch
A system power switch.
F2 DC-12V
DC-in connector for connecting DC power source (60W). Use only the power adaptor included within the package.
F3 LED
System (Green)
Status (Green/Amber)
Hdd (Yellow)
F4 Reset Switch
A hardware (default) or a software reset switch. You will need to set it to either hardware or software reset in the BIOS.
F5 Console Port
It is a console port via RJ45 connector. Using suitable RS-232 cable, you can connect an appropriate device, for example,
a terminal console for diagnostics.
Terminal Configuration Parameters: 115200 baud, 8 data bits, no parity, 1 stop bit , no flow control.
F6 4 10/100/1000 Gigabit Ethernet Ports
The Gigabit Ethernet ports are provided by Realtek RTL8111E-GR Integrated 10/100/1000 Ultra Gigabit Ethernet
Transceiver through the PCI-e interface. They support both Wake-on-LAN and remote wake-up. They also support the
IEEE 802 IP Layer 2 priority encoding and IEEE 802.1Q VLAN tagging.
LED Indicator LED Function
Left Link/Activity
Right Data Speed
F7 USB 2.0 Ports
It connects to any USB devices, for example, a flash drive. Besides this external USB port, there is another one with the
internal pin headers (refer to Jumper Setting on Chapter 3 Motherboard Information)
F8 PCI Expansion Slot
In addition to these two PCI expansion slots, there is also one internal Mini-PCI connector .
Network Application Platforms
F4 F5 F6
Green: when the system is on.
Off: when the system is off.
It is a programmable LED to show the operating status of the system. For
more details, look for the software utility folder in the Driver and User Manual
CD.
Flashing: when there are data access activities or when the CompactFlash
card or SATA disk (on model FW-6436B only) is present or both
Off: when there is no CF or SATA disk present..
LED Color
Yellow
Green
Orange
F7
On Off
connected Not connected
100 Mbps 10 Mbps
1000 Mbps
Introduction
Blinking
Linking/there is
traffic
3