Table of Contents
Advertisement
Chapter 2:
Hardware Setup
Preparing the Hardware Installation
To access some components and perform certain service
procedures, you must perform the following procedures
first.
WARNING: To reduce the risk of personal
injury, electric shock, or damage to the
equipment, remove the power cord to
remove power from the server. The front
panel Power On/Standby button does not
completely shut off system power. Portions of
the power supply and some internal circuitry
remain active until AC power is removed.
1.
Unpower the FW-8759 and remove the power cord.
2.
Unscrew the screws (two on each side and one on the
rear) from the top cover of the FW-8759 System.
3.
Slide the cover backwards and open the cover
upwards.
System Memory Installation
The motherboard supports DDR3/DDR3L memory that
features data transfer rates of 1066/1333/1600 MHz
(with unbuffered ECC or non-ECC) to meet the higher
bandwidth requirements of the latest operating system
and Internet applications. To install the memory:
1.
Open the DIMM slot latches.
2.
Install the DIMM.
1
Note:
All DIMMs installed must be the same speed
1.
(DDR3/DDR3L 1066/1333/1600MHz, unbuffered
ECC or non-ECC ). Do not install DIMMs
supporting different speeds.
The system can support up to 8 GB in maximum.
2.
Since the system is capable of dual channel
3.
architecture, insert DIMMS on both DIMM1
and DIMM2 slots to enable dual channel
configuration.
Hard Disk Installation
The system can accommodate two 2.5" Serial-ATA disks.
Follow these steps to install hard disks into the FW-8759:
1.
Unscrew the 4 screws on the hard disk tray to take out
the hard disk tray from the system.
2.
Place hard disk on the hard disk tray and align the
holes of the hard disk with the mounting holes on the
tray.
3.
Secure the hard disk with 4 mounting screws on the
hard disk tray.
4.
Connect the Serial-ATA power and data cables to the
hard disk's power and data connectors respectively.
5.
Plug the Serial-ATA cable to the Serial-ATA Connector
on the main board.
6.
Put the hard disk tray with the installed hard disk back
to the system and install it with the mounting screws.
1
2
Advertisement
Table of Contents
