Table of Contents
Advertisement
CPU and the Heat Sink Installation
The FW-7585 sever system is powered by the MB-7585
sever board, which comes with one ZIF type LGA1150
CPU socket.
Follow the procedure bellow for installing a CPU
1.
Press the socket lever and release it from the
retention tab.
2.
Lift the socket lever and then the plate.
3.
Remove the CPU socket cap.
4.
Align the notches in the CPU base and the tabs on the
socket. The CPU should fit perfectly into the socket.
Note that the CPU fits in the socket in only one
direction.
5.
Close the CPU cover plate by lightly pressing down on
the CPU cover plate while closing the socket lever.
6.
Peel off the sticker on the CPU to expose the thermal
compound.
7.
Align the heatsink's four mounting screws with the
mounting holes in the chassis. Carefully place the
heatsink on the CPU. Tighten each heatsink screw
a little at a time to ensure that the CPU stays level.
Tighten each set of diagonally opposed screws at a
time.
1
2
5
3
4
6
Note:
The CPU heat sink can only be installed in only
1.
one orientation as shown in the picture.
To protect the CPU socket pins, retain the CPU
2.
cap when the CPU is not installed.
7
Advertisement
Table of Contents
