Linear Acoustic AERO.2000 User Manual page 30

AERO.2000 User Guide July 2016
1. Select Display Options and press Right
2. Select Memory Slot 1 and press Right
3. Use Up/Down arrows to highlight a memory slot and press Right. A check mark will
appear next to your selection.
4. Press Left and then Down to highlight meter 1.
5. Press Right and use Up/Down arrows to select a meter type.
6. The first selection is a choice of the program output to monitor. Any of the three DRCs
can be chosen, or metering of the unit's I/O that is Common to all DRCs, or Off.
7. Press Right to see the selections and select Program 1. A check mark will appear. Press
Left to exit.
8. Use Down to select what to meter for Program 1. Press Right to see the choices. Use
Up/Down to select DRC-Program 1. A check mark will appear. Press Left to exit.
9. Press Left again to return to the meter selection screen.
10. Select meter 2 and Right to select a source. Select Program 1, and press Right. Use
Up/Down to select Program 1. Left to exit.
11. Use Down arrow to select a meter type, Right to see selections. Use Down arrow to
highlight LM (loudness meter) Program 1. The Right arrow to select Program 1, and Left
arrow to exit.
12. Use Up/Down arrows and highlight meter 3. Right arrow to enter the meter selection.
13. Use Down arrow to highlight Off. Press Right arrow to select and then Left Arrow to
exit.
14. Repeat steps 12 and 13 for meters 4, 5, and 6. See Figure 5-4 Left side for the result.
15. Use Up/Down keys to highlight Fullscreen Mode and press Right. See figure 5-4 right
side.
16. Press Left to exit full screen mode.
©2016 LINEAR ACOUSTIC INC. THE TELOS ALLIANCE. ALL RIGHTS RESERVED
L16/1/18039
Page 16