Http Setup; Front Panel Displays - Linear Acoustic AERO.2000 User Manual

AERO.2000 User Guide July 2016

5.5 HTTP Setup

5.5 HTTP Setup
5.5 5.5 HTTP Setup HTTP Setup
The AERO.2000 has a built-in HTTP server. Logs of LKFS (LUFS) readings can be accessed
through the HTTP server. IP commands, to control the unit remotely, and scripting functions
(Section 8) are found here as well as a copy of the latest Nf Remote application.
Only computers that have their IP addresses in the HTTP white list, found in HTTP Access, can
access the unit's HTTP server. We recommend that an IP address, in the same subnet as the
AERO.2000 IP address, is immediately entered in the white list and is also stored in a safe place.
A computer can be connected directly to the unit's Ethernet port using an ordinary Ethernet
cable. By setting the computer's IP address and subnet mask to the same IP and subnet mask
stored in the white list the computer can access the AERO.2000's HTTP server. This access can
even allow you to recover from a lost password without returning the unit to the factory!
From the AERO.2000 main menu use Up/Down arrows to highlight System and press Right
arrow.
Use Up/Down arrows to highlight Network access and press Right arrow.
Use Up/Down arrows to highlight HTTP Access and press Right arrow.
Use Up/Down arrows to highlight IP 1 and press Right arrow. The alpha numeric entry opens.
Using the same process used to set the IP address (above) set a white list IP address and subnet
mask for your PC/laptop.
An example of a valid entry is 192.168.1.200/255.255.255.0 . The subnet and subnet mask
must be the same as the AERO.2000 IP address assignment but must NOT be the same address.
The addresses of any PCs that will access the logs, control the AERO.2000 using commands over
IP, or is permitted to download the NfRemote software can be entered in the white list up to a
total of 8 addresses. Wild cards can also be used to allow an entire subnet access. Example:
192.168.1.*

5.6 Front Panel Displays

5.6 Front Panel Displays
5.6 5.6 Front Panel Displays Front Panel Displays
The front panel display can be customized, and can contain up to six meters of the same or
different types. The display can also be set to "Meters Only" mode so the menus are
temporarily hidden. Of course, display resolution may limit the number of active front panel
meters, but all six will look fine when displayed on a monitor using the AERO.2000 VGA output.
This is found on the rear panel. To setup meters use the Left arrow to navigate to the
AERO.2000 main menu.
©2016 LINEAR ACOUSTIC INC. THE TELOS ALLIANCE. ALL RIGHTS RESERVED
L16/1/18039
Page 15