16
en | Introduction
17 Connectors for eight analog inputs
18 Connectors for eight relay outputs
Notice!
All connectors, with the exception of the RS-232 and Ethernet
host interface, are pluggable screw clamp terminals.
Figure 3.5: Jumper at the bottom side
19 Jumper for setting either voltage free relay output ("dry"
20 Jumper: Equalization of potential between different
3.3
Performance Characteristics
–
–
–
2016-11 | AMC2-4W |
mode) or looped-in voltage from the AMC2 internal
power supply ("wet" mode).
systems and earth ground (shield) for the extension
interface.
Intelligent access manager for 1 - 4 entrances (for example
doors, man traps, barriers)
Host address selectable using DIL sliding switch.
Four possible configurable host interfaces:
–
Ethernet (= standard)
–
RS-485 2-wire
–
RS-485 4-wire
Access Modular
Controller
Bosch Sicherheitssysteme