Agilent Technologies 7697A Maintenance Manual page 14

2
Removing Covers and Components
14
If necessary, disconnect the transfer line from the
5
pneumatics assembly or GC.
a Remove the valve thermal enclosure. See
the Valve Thermal
Depending on your hardware configuration, remove the
b
valve cover, or the valve/loop cover. See
the Valve Cover"
Loosen the 3/16- inch nut in the internal reducer
c
(Figure 5).
Figure 5 3/16-inch internal reducer with valve cover removed and loop
cover shown (the valve/loop cover is similar)
d Remove the fused silica column from the internal
reducer.
Hold the transfer line by the mounting bracket, and
e
carefully slide the transfer line out of the Headspace
and set it aside.
Enclosure".
or "To Remove the Valve/Loop
"To Remove
"To Remove
Cover".
Maintenance