Masport LIFESTYLE 3 Owner's Manual page 8

Remove all packaging from inside the Hood (1). Remove cooking grills/plates. The Hood/Grill assembly (1) is very heavy and requires two persons to lift it into
place. Secure the grill body to the side retainers located on the side panels (2) & (3) using 4pcs Screw M6x10 (18).
The hood is packaged without the temperature gauge being assembled.
Loosen the screws located on the left and right side plates of the Grill Body Assembly (1). Lift, lower, and hook the Left Side Shelf (11) over
the loosened screws, securing it to the Grill Body Assembly (1). Repeat it to secure the Right Side Shelf (12) to the Grill Body Assembly (1).
Burner
body
NOTE:
Screws No. 18 are placed into position ready for the side table assembly.
14
STEP 6
18
18
4Pcs M6*10
STEP 7
4~6 mm
11
* *
18
Left side shown as an example
Open the lid of the Right Side Shelf (14) and insert the end of the Burner (16) into the corresponding hole in the Right Side Shelf (12).
Connect the end of the Burner (16) with the Gas Connection Elbow and then securely attach the Burner (16) using M4x6 Screws (24).
Connect the Ignition Lead wire to the Spark Electrode.
18
18
Remove the fasteners from the temperature gauge spindle, insert into the hood, align the gauge and tighten using the same fasteners.
Place the Flame Tamers (13) over burners using vent slots in back as a guide for positioning of the flame guards (as indicated).
NOTE:
If your barbecue has the grill/hotplate configuration, place the flame tamers only beneath the grill.
STEP 8
Gas
14
5 connection
elbow
Burner tube
24
STEP 9
14
Spark
electrode
Ignition lead
STEP 10
19
13
15