Technical Data; Troubleshooting - Masport LIFESTYLE 3 Owner's Manual

not in use. If the barbecue is to be stored indoors, the gas bottle must be disconnected and left outside. The gas bottle should always be
stored outside, in a dry, well-ventilated area, away from any sources of heat or ignition. Do not let children tamper with the bottle.
To protect your investment it is recommended that BBQs are protected by a suitable BBQ cover. But please note that prior to using a
protective cover, the BBQ should always be cool, cleaned of any surface contaminant or dirt and be thoroughly dry. Failure to follow this
information can lead to a BBQ cover being a corrosion breeder rather than a protective tool.
NOTE:
If leaving your BBQ covered for long periods, occasionally check for
corrosion and insect habitation. Oil surfaces for extra protection.
SERIAL NUMBER
The serial number of your barbecue is located on the side panel. If you do require any further assistance with your barbecue from your local
dealer or Masport, please have this serial number handy as it will quickly allow us to identify the barbecue.
Name Model
AGA7443 G BBQ 0.94
LIFESTYLE 3 CBA-301-ACYB
AGA7443 G BBQ 0.94
LIFESTYLE 4 CBA-401-ACYB
MAESTRO AGA7443 G
CBA-401-B-B
Gas Supply Pressure,
Min: 2.70kPa; Max: 3.45kPA
Gas Type:
NZ: Universal LPG
AUS: PROPANE
Minimum Clearance :
From Top of BBQ: 1000mm, From Sides: 430mm, From Rear : 430mm
Distributed by
MASPORT LTD
MASPORT LIMITED
1-37 Mt Wellington Highway,
Panmure, Auckland 1060, NZ
PO Box 14349, Panmure Auckland
1471, NZ
MASPORT AUSTRALIA PTY
LIMITED
1/40 Abbotts Road, Dandenong
South, Melbourne, Victoria 3175,
Australia
PO Box 533, Braeside, Victoria
3195, Australia
For storage and cylinder exchange, disconnect hose at the cylinder only, do not
disconnect hose from the appliance.
SERIAL N
O:
PANTONE 185C
26

Technical Data

AGA Injector Pressure Inp/Burn
Approval (mm) (kPa) (Mj/h)
3 x 11.5
2.75
S/B 0.89 1 x 10.0
4 x 11.5
2.75
S/B 0.89 1 x 10.0
BBQ 0.94 4 x 11.5
S/B 0.89 2.75 1 x 10.0
R/B 1.02 1 x 12.2
Tested to:
EU Directive 2009/142/EC
AS 4557-2004 (AMDT2)
Read the instructions before
using the appliance
USE OUTDOOR ONLY
WARNING: Parts of this
Manufactured by:
appliance may be very hot,
keep young children away
SIZE: 155mm x 160mm
BEFORE CALLING FOR SERVICE
If the grill does not function properly, use the following checklist
before contacting your dealer for service.
APPLIANCE APPROVED OUTDOOR USE ONLY
USE ONLY THE 5/8" x 18 GAS CONNECTION HOSE AND
REGULATOR PROVIDED BY THE MANUFACTURER!
If a replacement is necessary, please contact either our Masport
Customer Service Department or your local dealer.
The use of unauthorised parts can create unsafe conditions and
environment.
Refer to your Masport warranty card for warranty information.
Problems
Total
Integrated Ignition
(Mj/h)
When push the knob and turn anticlockwise:
44.5 - Won't light
- No spark
56.0
- Still no spark
- Weak spark
68.2
- Spark at places other than the tip of electrode
Electronic Ignition (Rear Burner)
When push the knob and turn anticlockwise:
- Won't light
- No spark
- Still no spark
- Still no spark
- Still no spark
- Weak spark
- Spark at places other than the tip of electrode
Burner can't light by match
Yellow or orange flames, with gas odour
Low heat with knob in High
Flare up
Flame out
Flame lifting
Flashback
Grease fire

Troubleshooting

STORAGE OF THE GRILL
1. Clean the BBQ.
2. Store the BBQ outdoors in a dry, well ventilated area and out of
reach of children when LP tank is connected to the grill.
3. Store the BBQ indoors ONLY after the LP tank is turned off and
removed, the LP tank must be stored outdoors, out of reach
of children, NEVER store the tank in a building, garage or any
other enclosed area.
4. If using a cover for your barbecue, check your BBQ every few
weeks.
CHECKLIST
Possible Cause
Orifice blocked
Dirty contacts of the electrode and or loose
contacts
Electrode terminals are damaged
Due to moisture / food residue on the electrodes
Ignition wire damaged
Orifice blocked
Dirty contacts of the electrode and or loose
contacts
Dirty / loose contacts at the battery
Dead / discharged Battery
Wrong polarity
Circuit incomplete due Loose contacts at the
ignition module
Electrode terminals are damaged
Due to moisture / food residue on the electrodes
Ignition wire damaged
No gas
Gas flow is not smooth
Incorrect assembly between burner and valve
Incomplete combustion
( )" Gas hose bent or kinked
position
Burner or orifice blocked
Low gas pressure
Grill not preheated
Excessive meat fat
Over high temperature
Grease deposit
Over high winds
Over high gas pressure
Burner port blocked
Grease accumulated in food
Solutions
Check the orifice for blockage
Remove the connecting wire, clean and reconnect
firmly
Inspect electrode and replace if damage
Remove the moisture using paper towel / clean the
electrode
Replace the ignition wire
Check the orifice for blockage
Remove the connecting wire, clean and reconnect
firmly
Clean
Replace battery
Check and insert the battery correctly
Re-assemble the ignition module make sure the
assembly is tight and makes a complete circuit
Inspect electrode and replace if damage
Remove the moisture using paper towel / clean the
electrode
Replace the ignition wire
Open the LP tank valve
Clear burner tubes
Re-assemble
Check the burner inlet for obstruction such as
spiders
Check air shutter for correct adjustment
Check for the source
Straighten
Clear
Check Cylinder/ Regulator (refer to pg. 15)
Preheat the grill for 15 minutes
Cut off fat before grilling
Adjust
Clean
Find a less windy place
Call the gas dealer
Clean
Turn off knobs, LP tank valve, leave lid open, let fire
burn out. Clean the grill when cool.
27