Adam Equipment NBL 84 e/i Operating Manual page 25

EN
10.4.3.3
Dynamic
When the " " symbol is displayed, and you have selected "SEtvP
balance for dynamic weighing (see section 10.4.3.3 on Dynamic Weighing Setup
Parameters):
Press [Setup] to select "SEtvP
The display will show "MODE
select "AvtO AvtO AvtO AvtO" or "mmAnvAL mAnvAL". mAnvAL mAnvAL
If "AvtO AvtO" or "mmAnvAL mAnvAL" is selected, the following 4 parameters are available:
AvtO AvtO mAnvAL mAnvAL
• Threshold
• Mode
• Delay
• Test time
10.4.3.3.1 Threshold
Press [Setup] when "THRESH
weight of the item required by the balance to start the process for dynamic weighing. The
value shown will be the current value in the last selected unit.
The minimum threshold value can be changed from 1.0 to 100 grams using the keypad
numeric entry method. If a value outside this range is selected then it will not be accepted
and "ER LOW ER LOW" or "ER HIGH ER HIGH" will be displayed followed by return to the weight entry screen
ER LOW ER LOW ER HIGH ER HIGH
again.
To confirm the desired value, press [Setup] or to escape without changing the value,
press [Mode].
10.4.3.3.2 Mode
Auto "AvtO AvtO" or Manual "mmAnvAL AvtO AvtO
[Setup] is pressed becomes the active mode. Auto starts dynamic weighing test as soon
as weight exceeding a set threshold is loaded on the pan. Manual requires the user to
load the pan and then press a button before weighing commences.
10.4.3.3.3 Delay
Press [Setup] when "DELAY
seconds pause before the sampling starts. The Delay value can be changed to between 0-
99 seconds using the keypad numeric entry method. If a value outside this range is
selected then it will not be accepted and "ER LOW
by return to the time entry screen again.
To confirm the desired value, press [Setup] or to escape without changing the value,
press [Mode].
10.4.3.3.4 Test time
Press [Setup] when "TESt t
seconds over which the balance will average to compute the final weight. The Test time
© Adam Equipment Company 2015
Dynamic (Animal) Weighing Setup Parameters
SEtvP SEtvP" to change the dynamic weighing mode settings. SEtvP
MODE MODE". Press [Setup] again and use the [Up] or [Down] keys to MODE
"THRESH THRESH"
THRESH THRESH
"mode mode" mode mode
"DE DELAY DE DE LAY" LAY LAY
"TEST T TEST T" TEST T TEST T
"THRESH THRESH THRESH" (For Auto mode only) THRESH
THRESH THRESH THRESH" is shown and the display will next show the minimum
"mode mode" mode mode
mAnvAL" modes are available. Whichever mode is visible when mAnvAL mAnvAL
"DELAY DELAY" DELAY DELAY
DELAY" is shown and the display will next show the number of DELAY DELAY
"TEST T TEST T TEST T" TEST T
TESt t" is shown and the display will next show the number of
TESt t TESt t
ER LOW" or "ER HIGH ER LOW ER LOW ER HIGH" will be displayed followed ER HIGH ER HIGH
24
SEtvP" to set up the
SEtvP SEtvP
3016612481Rev2.00-Jul15