Lutron Electronics QSGRK-6D Quick Installation And Operation Manual page 20

Daylight Sensor Setup
Group Mode (continued)
Select Sensors
Daylight Sensor
1. Press the Timeclock (back) button to return to the Daylight
Setup Sensor menu.
2. Use the Master buttons to highlight "Setup" and press the
Calibrate
OK button to accept.
3. Use the Master buttons to scroll through the list of available
daylight sensors. When the desired sensor is displayed, press
Sensor x/y
the OK button to select it.
SN: xxxx-xxxx
4. Use the Master buttons to scroll through the list of available
groups. When the desired group is displayed, press OK
Source: RF
to assign or unassign the sensor to that group. Press the
Timeclock (back) button to return to the list of available
sensors and repeat for additional sensors.
Sensor x
5. Calibrate sensors: Press the Timeclock (back) button to return
Group 1
to the Daylight Sensor screen. Use the Master buttons to
select the desired group and press the OK button to accept.
*Unassigned*
6. Use the Master buttons to select the desired group and press
the OK button to accept.
Sensor x
7. Put any wireless Radio Powr Savr
associated with the desired groups into Calibrate Mode:
Group 1
Press and hold the "Cal" button for 6 seconds until the sensor
flashes.
*Assigned*
8. Use the Master buttons to select the desired light level for
the group, and press the OK button to accept. Repeat for all
group levels you wish to calibrate. Press the OK button to
accept.
9. Exit programming mode (see page 9).
Note: If wireless sensors are not found, verify that they are
associated correctly (see page 16).
Daylight Sensor
Setup
3 seconds
Calibrate
®
1 9 2 10 3 11 4 12
daylight sensors
TM
Adjust Light
Calibrate
More light
Group 1
Less light
For additional information, see the complete installation and operation guide at www.lutron.com/qs
GRAFIK Eye
5 13 6 14 7 15 8 16
9-16
1-8
Saved
Saved
QS with DALI Quick Installation and Operation Guide 20
®
Master
buttons
OK
OK
button
Timeclock
(back) button
Cal
button