Lutron Electronics QSGRK-6D Quick Installation And Operation Manual page 13

DALI Setup
Assign/Unassign a DALI Device to a Zone (Zone setup)
DALI devices must be addressed on the system (see previous page) before assigning
or unassigning to a zone.
1. Enter programming mode (see page 9).
Main menu
2. Use the Master buttons to highlight "DALI" and press the OK
Zone setup
button to accept.
Zone setup
DALI 3. Use the Master buttons to highlight "Assign zones" and press
the OK button to accept.
4. Use the Master buttons to scroll through the DALI devices on
DALI
the link. The selected device will flash, and the info screen
will display the device number and the number of devices on
Assign zones
the link. If the device is currently assigned to a zone, the zone
number will display at the bottom of the screen and the LEDs
Address All
for the zone will go on; otherwise, the info screen will display
"*Unassigned*".
Assign zones
• Press the zone raise button to assign the device to that
zone.
Ballast 2 / 23
• Press the zone lower button to unassign the device to that
zone.
*Unassigned*
5. Press the timeclock (back) button to return to the DALI menu.
DALI devices will return to normal levels.
Assign zones
6. Exit programming mode (see page 9).
Ballast 2 / 23
Notes
Zone 3
Devices that were previously assigned to a zone will be
removed from the old zone and assigned to the new zone
(each device can be assigned to only 1 zone at a time).
Devices can be assigned only to zones set to DALI load type.
Refer to page 11 for instructions on changing load type.
®
1 9 2 10 3 11 4 12
For additional information, see the complete installation and operation guide at www.lutron.com/qs
GRAFIK Eye
5 13 6 14 7 15 8 16
9-16
1-8
1 9 2 10
Zone LEDs
QS with DALI Quick Installation and Operation Guide 13
®
Master
buttons
OK
OK
button
Timeclock
(back) button
3 11 4 12 5 13 6 14 7 15 8
Use the
zone raise
or lower
button to
assign or
unassign
a DALI
device to
that zone.
16