Lutron Electronics QSGRK-6D Quick Installation And Operation Manual page 11

Zone Setup
Assign Load Types
Load types supported by the GRAFIK Eye
• Digital load
• DMX
• RGB/CMY DMX
• Non-dim digital
Note: For all DMX or RGB/CMY DMX lighting, an external
DMX interface (such as the QSE-CI-DMX) must be
used with the control unit.
1. Enter programming mode (see page
Main menu
9).
CCI Mode
2. Use the Master buttons to highlight
Zone setup
"Zone setup" and press the
OK button to accept.
3. Use the Master buttons to highlight
"Load type". Press the OK button to
Zone Setup
accept.
Load Type
4. Use the zone raise/lower buttons to
Non-Dim Load Type choose the load type for that zone.
Press the OK button to accept.
5. The info screen will confirm that your
load type has been saved.
Load Type
6. Exit programming mode (see page 9).
Set zones
Saved
®
1 9 2 10 3 11 4 12
QS with DALI:
®
Assign Non-Dim Load Type
Zones assigned to non-dim loads have three available configurations:
Main menu
CCI Mode
Zone setup
Zone Setup
Load Type
Non-Dim Load Type
Load Type
Set zones
For additional information, see the complete installation and operation guide at www.lutron.com/qs
GRAFIK Eye
5 13 6 14 7 15 8 16
9-16
1-8
1 9 2 10
• LOFO: Last On, First Off
• FOFO: First On, First Off
• FOLO: First On, Last Off
Scenes made up of both dim and non-dim
load types will toggle the non-dim loads
before the dim loads in a "First" on/off
configuration, and after the dim loads in a
"Last" on/off configuration.
1. Enter programming mode (see page 9).
2. Use the Master buttons to highlight "Zone
setup" and press the OK button to accept.
3. Use the Master buttons to highlight "Non-Dim
Load type". Press the OK button to accept.
4. Use the zone raise/lower buttons to choose
the non-dim load type for that zone. (Zones
not programmed as non-dim will be displayed
as Unaffected.) Press the OK button to
accept.
5. The info screen will confirm that your load
type has been saved.
Saved
6. Exit programming mode (see page 9).
QS with DALI Quick Installation and Operation Guide 11
®
Master
buttons
OK
OK button
3 11 4 12 5 13 6 14 7 15 8
Use the
zone
raise/lower
buttons to
choose the
load type for
that zone.
16
1