Using Test Patterns - Barco ACS-2048 User Manual

rëáåÖ=qÉëí=m~ííÉêåë
Pressing the TEST PAT button selects the internal test pattern as the ACS-2048's source.
There are two ways to use the button:
TEST
PAT
•
•
Please note the following important points regarding test pattern usage:
•
•
•
ACS-2048 • User's Guide
~
Condition 2: A source is currently showing on the output.
• When you select a new source, the system transitions to black.
Once the "auto acquire" of the new source is complete, the
system transitions to the source.
~
Condition 3: A test pattern is showing on the output.
• When you select a new source, the system transitions the test
pattern off, and then follows the rules outlined for conditions 1
or 2 — depending on the current situation.
When TEST PAT is pressed, the button lights, and the internal test pattern is
routed to the output. When you select another input, the system transitions to the
new input.
When the TEST PAT button is already lit, press the TEST PAT button again to
toggle back to the last selected input.
Note If the Menu Context mode is
Menu, the Test Patterns Menu appears whenever the TEST
PAT button is pressed, allowing you to select an internal test
pattern and adjust additional test pattern parameters.
When Menu Context is ON
pattern is automatically enabled, and the Type field is selected, enabling you to
change patterns easily.
If you need to change the state of the Raster Box in this mode, press ESC, scroll
to the Raster Box field, and change the function as required.
Regardless of the Menu Context mode, pressing TEST PAT has no effect on the
state of the Raster Box. It always remains in its last selected mode.
ON in the User Preference
and TEST PAT is pressed, the last selected test
4. Operation

Using Test Patterns

71