Barco ACS-2048 User Manual page 70

4. Operation
Using Inputs
•
Figure 4-46. Error message: Invalid Selection
•
råÇÉêëí~åÇáåÖ=^ìíç=^ÅèìáêÉ
Please note the following important points regarding the Auto Acquire mode:
•
•
•
70
Input 8 is currently not implemented. If the input button is pressed, the following
message appears:
I n v a l i d S e l e c t i o n
Opt i on Card
No t Inst alled
Remember that the Menu Context option on the User Preference Menu affects
the way that menus are displayed. Refer to the
page 63 for details.
If In Auto Acquire is ON and a valid input is selected that does not have a saved
input configuration file associated with it, the system attempts to acquire the
source, save an input configuration file, and smoothly transition to the new source.
Note The input configuration file will only be saved if the "Auto
Input Save" mode is
Two different error messages can be displayed when In Auto Acquire is ON:
~
Mismatch: The ACS-2048 cannot match to any saved input
configuration, or to any format in the input format table.
~
Invalid Signal: No valid input signal is detected.
If In Auto Acquire is OFF
configuration file, the system compares the library file to the input's timing.
~
If the timings match, the system transitions to the input.
~
If the timings do not match, the system displays black and the "Invalid
Signal" message appears.
Three error messages can be displayed when In Auto Acquire is OFF:
~
Mismatch: The ACS-2048 cannot match to any saved input
configuration, or to any format in the input format table.
~
Invalid Signal: No valid input signal is detected. In this situation, the
video output will be black.
~
No Saved File: A configuration file has not been saved for the input.
When a new (unsaved) input is selected, the system performs one of three "auto
acquire" sequences, depending on the current system condition:
~
Condition 1: No source is currently selected, and the output is black.
This condition occurs after a factory reset.
• When you select a new source, the system transitions to the
source — once the "auto acquire" is complete.
"User
ON in the User Preference Menu.
and a valid input is selected with a saved input
Preference" section on
ACS-2048 • User's Guide