Barco ACS-2048 User Manual page 30

3. Installation
Format Connection Table
2.
3.
This completes system signal installation. Please continue with system setup, menu
orientation and operations, as outlined in Chapter 4, "Operation" on page 31.
cçêã~í=`çååÉÅíáçå=q~ÄäÉ
Use the following table to connect various source formats to the ACS-2048, using the
universal input connectors (on Input 4 and Input 5) in conjunction with a customer supplied
VGA to 5 x BNC breakout cable. Please note:
•
•
Using a customer supplied VGA to 5 x BNC breakout cable, multiple input combinations
are possible. Cells with checks denote the connections required for the indicated format.
Table 3-2. Analog Input Combinations using Breakout Cable
Breakout Cable
Wire Color
R
G
B
H Sync
V Sync
Please contact Barco Technical Support for information on obtaining breakout cables. In
Appendix C, refer to the
30
Output connections:
a. If you are operating the ACS-2048 in 10-bit or 12-bit mode, connect both
DVI outputs (A and B) to the projector's DVI inputs A and B.
b. If you are operating the ACS-2048 in 8-bit mode, connect DVI output A to
the projector's DVI input A.
Communications connection:
a. Connect the ACS-2048's Ethernet port to an Ethernet switch, and
connect the switch to the other Ethernet devices in your local system
(e.g., laptop, projector, etc.). This connection enables you to
communicate with the ACS-2048 via Telnet. In Appendix B, refer to the
"Communicating with
RGB format — typical devices: Computers
YUV or YP P (Betacam) format — typical devices: DVD player, Betacam deck
b r
Important Inputs 4 and 5 do not support Composite or S-Video formats.
Note For RGB with H and V sync, use the VGA connector directly
(Input 4), or all five BNCs (Input 5).
YUV
(YP P )
b r
(P )
r
(Lum)
(P )
b
"Contact Information" section on page 108 for details.
ACS-2048" section on page 93 for details.
RGB RGB
Sync on Green Comp Sync
ACS-2048 • User's Guide
RGB
Separate H V