Barco ACS-2048 User Manual page 22

2. Hardware Orientation
ACS-2048 Front Panel
•
3
DVI-I
•
4
Analog
HD-15
•
5
Analog
5-BNC
•
6
CVBS
•
7
Y/C
•
8
Option
•
TEST
PAT
22
3 — selects a digital DVI or analog RGBHV input (the front panel Input 3
connector) as the source.
4 — selects a YUV or RGBHV input (the front panel Input 4 connector) as the
source.
5 — selects a YUV or RGBHV input (the front panel Input 5 connector) as the
source.
6 — selects a Composite NTSC or PAL input (the front panel Input 6 connector)
as the source.
7 — selects an encoded NTSC or PAL Y/C input (the front panel Input 7
connector) as the source.
8 — this input is currently not implemented.
TEST PAT — selects the internal test pattern as the source.
There are two ways to use the TEST PAT button:
~
When TEST PAT is pressed, the button lights, and the internal test
pattern is routed to the output using a CUT transition. When another
input is selected, the system transitions to the new input.
~
When the TEST PAT button is already lit, press the TEST PAT button
again to toggle back to the last selected input.
Note If the Menu Context mode is
Menu, the Test Patterns Menu appears whenever the TEST
PAT button is pressed, allowing you to select an internal test
pattern and adjust additional test pattern parameters.
In Chapter 4, refer to the "Using Test
ON in the User Preference
Patterns" section on page 71 for details.
ACS-2048 • User's Guide