Cable Preparation (Remote Systems Only) - ABB WaterMaster FET100 User Manual

WaterMaster FET100
Electromagnetic floweter | Transmitter
AC/DC Power
Supply Terminal
Backplane
Internal Earth
(Alternative PE)
Power Cable
Fig. 3.4 Cable Gland / Conduit Entry (Remote Transmitter Shown)

3.3 Cable Preparation (Remote Systems Only)

To prepare the cable for connection at the transmitter and sensor terminal blocks:
1. Remove the outer cable insulation and Mylar
2. Ensure the drain wire is sleeved.
3. Cut the cable connection wires to the lengths shown in Fig 3.5, page 12.
OI/FET100–EN Rev. A
External Earth
Output Connections
Output Connections
®
wrap.
3 Electrical Installation
Test Points for
Output Connections
Sensor
Cable Terminal
Output
Connections
Terminal
Internal Earth
(Alternative PE)
Sensor Cable
11