Health & Safety - ABB WaterMaster FET100 User Manual

WaterMaster FET100
Electromagnetic floweter | Transmitter
1.3 Health & Safety
Health and Safety
To ensure that our products are safe and without risk to health, the following points must be noted:

The safety requirements of this equipment, any associated equipment and the local
environment must be taken into consideration during installation.

Install and use this equipment and any associated equipment in accordance with the relevant
national and local standards.

The relevant sections of these instructions must be read carefully before proceeding.

Warning labels on containers and packages must be observed.

Installation, operation, maintenance and servicing must only be carried out by suitably trained
personnel and in accordance with the information given.

Normal safety precautions must be taken to avoid the possibility of an accident occurring when
operating in conditions of high pressure and / or temperature.

Chemicals must be stored away from heat, protected from temperature extremes and powders
kept dry. Normal safe handling procedures must be used.

When disposing of chemicals ensure that no two chemicals are mixed.

Product liability – advice and assistance provided without charge is given in good faith but
without liability.
Safety advice concerning the use of the equipment described in this manual or any relevant hazard
data sheets (where applicable) may be obtained from the Company address on the back cover,
together with servicing and spares information.
Warning.

System configuration must be carried out only by users or personnel with approved access rights
(user privileges).

Read all relevant sections of this guide before configuring the system or modifying system
parameters.

Install and use associated equipment in accordance with the relevant national and local
standards.
OI/FET100–EN Rev. A
1 Safety
3