Making Wi-Fi Settings By Pin Code Setup (Wps) - Epson XP-15000 Series User Manual

User's Guide
5. Hold down the [WPS] button on the access point until the security light flashes.
If you do not know where the [WPS] button is, or there are no buttons on the access point, see the
documentation provided with your access point for details.
6. Press the OK button on the printer.
7. Press the OK button.
The screen automatically closes after a specific length of time.
Note:
If connection fails, restart the access point, move it closer to the printer, and try again. If it still does not work, print a
network connection report and check the solution.
8. Press the button.
Related Information
"Checking the Network Connection Status" on page 29
&
"When You Cannot Make Network Settings" on page 144
&

Making Wi-Fi Settings by PIN Code Setup (WPS)

You can automatically connect to an access point by using a PIN code. You can use this method to set up if an
access point is capable of WPS (Wi-Fi Protected Setup). Use a computer to enter a PIN code into the access point.
1. Select Wi-Fi on the home screen.
To select an item, move the focus to the item using the
2. Select Wi-Fi (Recommended).
If the printer has already been connected by Ethernet, select Router.
3. Press the OK button.
If the network connection is already set up, the connection details are displayed. Select Change Settings to
change the settings.
If the printer has already been connected by Ethernet, select Change to Wi-Fi connection., and then select Yes
after checking the message.
Network Settings
u d l r
buttons, and then press the OK button.
26