Installing The Camera To The Mounting Plate - Bosch AUTODOME IP 4000 HD Installation Manual

AUTODOME IP 4000 HD
11.6

Installing the Camera to the Mounting Plate

1.
2.
Figure 11.6: Safety tether
3.
Ground wire
1.
Bosch Security Systems
Route the cables from the ceiling out of the side of the mounting plate with the crescent-
shaped cut-out.
Attach the hook of the safety tether from the adapter to the bottom of the camera.
Connect ground wire from the ground lug on the adapter to the center terminal on the 3-
pin terminal block for 24 VAC at the bottom of the camera.
Connect the mating connectors from the user-supplied cables from the ceiling to the
matching connectors from the camera. Refer to the chapter Connection, page 49 for
more information.
Installation Manual
Installing a Pipe Mount and Camera | en 41
2015.11 | 1.1 |