Bosch AUTODOME IP 4000 HD Installation Manual page 42

42 en | Installing a Pipe Mount and Camera
Figure 11.7: Connect cables
2.
3.
Notice!
Do not loosen the three brass buttons. These brass buttons engage the slotted tabs (item 5)
on the mounting plate.
4.
5.
2015.11 | 1.1 |
Unlock the single safety locking screw on the base of the unit using the T10 Torx
screwdriver (item 2 in the following figure).
Attach the camera to the mounting plate by inserting the vertical tab on the plate into the
recessed slot on the top of the camera dome to the right of the safety locking screw.
Rotate the camera approximately 15 degrees in a clockwise direction to lock firmly into
place (item 1 in the following figure).
Secure the safety locking screw with the T15 Torx screwdriver (item 2 in the following
figure).
Installation Manual
AUTODOME IP 4000 HD
Bosch Security Systems