Table of Contents
Advertisement
This section describes the operating principles of Digital key and Proximity Key/Card systems.
+
Only the Installer can program the Keys/Cards and Readers.
Readers ECLIPSE Key Readers and PROXI Card Readers are equipped with 3 System status LEDs (Red, Green and Am-
ber).
The Readers can be programmed to control:
----specific partitions (Reader partitions)
----type A arming mode (Amber LED)
----type B arming mode the (Green LED)
Keys/Cards Academy40 supports 250 Keys/Cards and an unlimited number of clones (clones of key/card 250).
Each key/card can be programmed with specific attributes, and can be enabled on selected partitions, as per Cus-
tomer requirements.
During the programming phase, the Keys/Cards will be programmed with the system access code (a random code
selected from 4 billion codes), and will be assigned a progressive Identifier number (1 through 250). Once the
Identifier number has been established, it will be possible to assign a 16 character label (name) to the Key/Card.
Using DKC Keys
Insert a DKC Key into a BP13 or BP13W Reader----all the Reader LEDs will switch OFF.
with BP13 and
BP13W
Ø Press the Key button for about 2 seconds.
Ø Extract the key when the LEDs indicate the required arming mode:
RED = Global Arming; AMBER = Type A Arming; GREEN = Type B Arming.
+
Do not press the button for more than 4 seconds, as the system will read this an 'Abandoned Request' (the LEDs
will blink, and the system status will remain unchanged).
Using the
Insert a SAT Key into an ECLIPSE Reader----all the Reader LEDs will switch OFF.
Eclipse/Sat
system
Ø Push the SAT Key gently into the Eclipse Reader.
Ø Extract the SAT key when the LEDs indicate the required arming mode:
RED = Global Arming; AMBER = Type A Arming; GREEN = Type B Arming.
Using the PROXI
Hold a PROXI Key near the sensitive field of the PROXI Reader (see dashed circle a) in Figure 2)----all the
CARD system
Reader LEDs will switch OFF.
Ø Hold the PROXI Card near sensitive field of the PROXI Reader until the LEDs indicate the required arming mode:
Ø Move the PROXI Card away.
RED = Global Arming; AMBER = Type A Arming; GREEN = Type B Arming.
Multiple
The Keys/Cards can be programmed to control several systems, with different access levels (enabled Readers,
Systems
Partitions, etc.), this in no way complicates use, as the procedures are exactly the same on all systems.
n Controlling the system
The operations described in this section will effect only the partitions of the Key/Card and Reader in use.
+
Only the Installer can enable the Keys/Cards and Readers on the Partitions.
The Keys/Cards can control the following operations:
Ø Global Arming: (Red LED ON) ALL the Key/Card and Reader partitions will arm.
Ø Global disarming: (all LEDs OFF) ALL the Key/Card and Reader partitions will disarm.
Ø Type A and B arming: (Amber or Green LED ON) ALL the Key/Card and Reader partitions will arm or disarm (as
programmed).
Ø Stop Alarm: All the signalling devices assigned to the Key/Card and Reader partitions will reset to standby status.
CONTROLLING THE SYSTEM VIA KEYS OR CARDS
CONTROLLING THE SYSTEM VIA KEYS OR CARDS
13
Advertisement
Table of Contents
