Ez-Ice Connector - Analog Devices ADSP-2181 Manual

Connectors

EZ-ICE Connector

The ADSP-218x EZ-ICE Emulator aids the debugging of an ADSP-2181
system. The emulator consists of hardware, host computer resident soft-
ware, and the target board connector. The ADSP-2181 integrates on-chip
emulation support with a 14-pin ICE-Port interface
interface provides a simpler target board connection that requires fewer
mechanical clearance considerations than other ADSP-2100 EZ-ICEs.
The ADSP-2181 device need not be removed from the target system when
using the EZ-ICE, nor are any adapters needed. Due to the small foot-
print of the EZ-ICE connector, emulation can be supported in final board
designs.
The EZ-ICE performs provides:
• In target operation
• Setting up to 30 breakpoints
• Single stepping or full speed operation
• Examining and altering registers and memory values
• Uploading and downloading PC functions
• Instruction-level emulation of program booting and execution
• Complete assembly and disassembly of instructions
• C source-level debugging
The EZ-ICE header is a 14-pin header with the connections shown in
Figure 3-9
3-12 ADSP-2181 EZ-KIT Lite Evaluation System Manual
(Figure 3-3). This