Table of Contents
Advertisement
Access the Machine Status menu by pressing
Use the keys
and
Setting the Setpoint:
Displaying probes:
To access the 'Programming' menu, press the
will be requested: 'PA1' for User parameters and 'PA2' for Installer parameters (see 'PASSWORD' paragraph).
User Parameter: When accessed, the display will show the first parameter (e.g. 'diF'). Press
the current level. Select the desired parameter by pressing
Installer Parameter: When accessed, the display will show the first folder (e.g. 'CP'). Press
current level. Select the desired folder using
parameter using
. Press
NOTE: Make sure you switch the instrument off and on again each time the parameter configuration is changed, in order to prevent mal-
functioning in the configuration and/or timing in progress.
MACHINE STATUS MENU
and releasing the key. If no alarms are active, the 'SEt' label appears.
to scroll through all the folders in the menu:
To display the Setpoint value press the
The Setpoint value appears on the display. To change the Setpoint value, press the
seconds. Press
to confirm the modification.
When label Pb1 is present, press the
the value cannot be modified).
PROGRAMMING MENU
key for more than 5 seconds. If specified, an access PASSWORD
. Press
and
to modify it and
- AL:
alarms folder (only visible if an alarm is active);
- SP1:
Setpoint 1 setting folder;
- Pb1:
probe 1 - Pb1 folder;
key when the 'SEt' label is displayed.
key to view the value measured by the corresponding probe (NOTE:
. Press
and
to modify it and
and
to scroll through the parameters in the current folder and select the
to save the changes.
and
and
to scroll through all the parameters on
to save the changes.
and
to scroll through the folders on the
keys within 15
Hide quick links:
Advertisement
Table of Contents
Need help?
Do you have a question about the ICPlus 902 and is the answer not in the manual?
Questions and answers