Introduction; Identification Of Components - Sullair ES-8 Operator's Manual And Parts List

2.1 INTRODUCTION

This manual provides information and recommen-
dations for installing, operating and servicing the
ES---8 Integral Compressor/Air Dryer. The unit is de-
signed and manufactured to the highest quality
standards. Units have been fully tested and in-
spected by the manufacturer before shipment from
the factory.
The information, specifications and illustrations in
this manual are in accordance with information in ef-
fect at the time of printing. The manufacturer re-
serves the right to change design and specifications
without notice and without incurring obligations.
It is extremely important to analyze completely every
system and understand the intended function of
each component before attempting to determine
the cause of a malfunction or failure.
The refrigerant (R---22) and air circuit can be easily
follow ed by referring to Figure
A refrigerant suction pressure gauge is provided as
Figure 2 ---1 Identification of Components (Typical)

2.2 IDENTIFICATION OF COMPONENTS

2 --- 2.
MPF FILTER
DESCRIPTION
standard equipment for analyzing the system op-
eration and performance.
Any question or problem not covered herein can be
directed to the nearest Sullair representative. Al-
ways specify the model and serial number of the
compressor/dryer on all correspondence regarding
service and parts.
Refer t o Figure 2 --- 1. Pa rts can be ordered from t he
nearest Sullair representative. If for any reason parts
cannot be obtained in this manner, contact the fac-
tory. Authorization and shipping instructions must
be obtained from the factory before returning the
parts to the factory. The manufacturer will not be re-
sponsible for parts returned without proper authori-
zation or identification.
The ES---8 Integral Compressor/Air Dryer is de-
signed for the purpose of removing moisture from
compressed air by cooling to a temperature of 35_F
to 39_F (2_C to 4_C).
MPF FILTER
SEPARATOR
FILTER
Section 2
7