Table of Contents
Advertisement
2.5 Buttons for washer-dryers
2.5.1
"ELECTRONIC DRYING"
It is possible to select three different electronic levels of dryness: one for
COTTON and one for SYNTHETICS cycles:
L19
Extra dry (cotton)
L20
Store dry (cotton)
L21
Iron dry (cotton)
L22
Store dry (synthetics)
The drying time is automatically calculated by the "Fuzzy" logic.
The drying phase can be performed either as automatic drying phase (non stop programme), if
previously selected together with the washing programme, as well as a separate drying phase.
DRYING TIME"
2.5.2
When this button is pressed it is possible to select (5 minutes a time) from 10
to 130 minutes drying for COTTON cycles and from 10 to 100 minutes for
SYNTHETICS cycles.
The drying cycle can be selected both as automatic drying and as separate
drying cycle.
L23
drying (full power)
L24
synthetic drying (half-power)
2.6 "START/PAUSE" button
♦ START: After selecting the programme and the desired options, press
the START button to start the programme. The LED positioned above the
button will cease flashing and remain lit. If a delayed start time has been
selected, the countdown will commence; the countdown will be shown on
the display.
♦ PAUSE: When the button is pressed again, the programme currently being
performed is interrupted.
The LED above the button will start to flash. When the cycle is paused,
the door LED switches off and the door can be opened on
condition that:
-
the machine is not performing a heating phase
-
the water level is not high
-
the drum is not in movement
When the appliance is paused, the programmes can be modified as follows:
→ The structure can be changed or the programme cancelled (SKIP/RESET button). In this case,
the water (and detergent) will not be drained and the new cycle will begin with water in the tub.
If it is preferred to restart the new cycle without saving water and detergent, it is necessary first
to select a drain phase and then the new programme.
→ The FABRICS and the TEMPERATURES can be modified only during the washing phase; in
this case, the cycle will be restarted from the beginning.
→ The SPIN can be modified before the start of the final spin cycle.
→ All the cycle OPTIONS can be modified before the commencement of the phase to be
modified.
→ DRYING selections can be modified before the starting of the drying phase.
To re-start the cycle, press the START/PAUSE button again.
♦ Water drain and spin cycle: after the "rinse hold" phase press this button to start the cycle with the
drain and final spin again.
SOI/DT 2002-06 eb
12
599 35 27-25
Advertisement
Table of Contents
