Table of Contents
Advertisement
2.4.2
"RINSE HOLD" button or "NIGHT CYCLE"
This function is available for COTTON, SYNTHETICS, DELICATES and WOOL cycles; in certain models, it
is combined with the SPIN button.
When this option is selected, the appliance will not drain the tub at the end of the final rinse and at the end
of the cycle, the LED corresponding to the START/PAUSE button (and, where applicable, the phase
indicator LED) will begin to flash to indicate to the user that the water in the tub must be drained.
In COTTON cycles it adds three rinses and eliminates all spin cycles
In SYNTHETICS cycles it adds a rinse and eliminates all spin cycles
In all OTHER cycles it eliminates all spin cycles
The following options can be selected to complete the programme:
drain and spin: Press START/PAUSE. The appliance will drain the tub and then perform a spin cycle at
the maximum speed for the programme previously selected;
select a spin speed using the SPIN button and then press START/PAUSE;
drain only: Press SKIP/RESET once, until the DRAIN LED lights, then press START/PAUSE.
In the case of WASHER-DRYERS, this option can not be selected, if the drying phase at the end of the
cycle has already been selected.
2.4.3
"SOAK" button
This option can be selected in COTTON, SYNTHETICS and DELICATE FABRICS cycles (but only in the
programme selection phase), and adds a pre-wash at the beginning of the cycle which consists of the
following phases:
water fill and heating at 30º C
a soak phase of about 30 minutes. The DELAYED START button (if featured) can be used to select a
SOAK time from 1 hour to 24 hours. The delay time will be shown in hours in the display window during
the selection phase; after the cycle has been started, the delayed-start countdown will be shown in
hours until it falls below 10 hours, after which the time will be shown in hours and minutes.
the water is drained and the appliance passes to the subsequent phase.
The SOAK option cannot be selected together with the STAINS and PRE-WASH options.
2.4.4
"STAINS" button
The STAINS option can be selected in COTTON, SYNTHETICS and DELICATE FABRICS cycles with
temperatures of 40°C or higher, and can also be selected during the washing phase.
This option adds the STAINS phase, in which special additives are introduced into the tub from the pre-wash
compartment after the BIO phase with heating to 40°C, and an additional 10 minutes of motor movement.
The STAINS option cannot be selected together with the PRE-WASH/SOAK, INTENSIVE and QUICK
/DAILY options.
2.4.5
"ECONOMY" button
This option is available only in cycles for COTTON and SYNTHETICS with temperatures of 30°C or higher.
The ECONOMY option reduces the temperature of the programme and increases the drum movement
phases after the heating phases.
The ECONOMY option cannot be selected together with the INTENSIVE / HEAVY / LIGHT SOILING and
QUICK CYCLE / DAILY options.
SOI/DT 2002-06 eb
10
599 35 27-25
Advertisement
Table of Contents
