Installing A Gbic With A Handle - Cisco ONS 15454 Troubleshooting Manual

Chapter 1 General Troubleshooting
Figure 1-38 GBIC Installation (with Clips)
Step 5 Slide the GBIC through the flap that covers the opening until you hear a click. The click indicates the
GBIC is locked into the slot.
Step 6 When you are ready to attach the network fiber-optic cable, remove the protective plug from the GBIC
and save the plug for future use.
Step 7 Return to your originating procedure (NTP).

Installing a GBIC with a Handle

Step 1 Remove the GBIC from its protective packaging.
Step 2 Check the label to verify that the GBIC is the correct type (SX, LX, or ZX) for your network.
Step 3 Verify that you are installing compatible GBICs; for example, SX to SX, LX to LX, or ZX to ZX.
Step 4 Remove the protective plug from the SC-type connector.
Step 5 Grip the sides of the GBIC with your thumb and forefinger and insert the GBIC into the slot on the
E1000-2, E1000-2-G, G1K-4, or G-Series card.
November 2004
E1000
2
Plug
FAIL
ACT
SF
RX
1
TX
ACT/LINK
ACT/LINK
RX
2
TX
1.10.2 Faulty Fiber-Optic Connections
Cisco ONS 15454 Troubleshooting Guide, R4.6
1-101