Typical Installation - FUTABA 6K Instruction Manual

%HIRUH XVLQJ WKH UHFHLYHU EH VXUH WR UHDG WKH SUHFDXWLRQV OLVWHG LQ WKH IROORZLQJ SDJHV

(Typical installation)

0RGH 6ZLWFK
Use the small plastic screw
driver that was included with your
receiver.
Switch is also used for the CH
PRGH VHOHFWLRQ &+ ⇔ 6%86
LED Indication
Green Red
Off Solid
Solid Off
Alternate blink
DANGER
Don't connect a connector, as shown in a
before figure.
,W ZLOO VKRUWFLUFXLW LI FRQQHFWHG LQ WKLV ZD\ $ VKRUW FLUFXLW
$,53/$1(VV WKH EDWWHU\ WHUPLQDOV PD\ FDXVH DEQRUPDO
KHDWLQJ ¿UH DQG EXUQV
Don't connect servo for conventional system
to S.BUS2 port.
'LJLWDO VHUYR IRU FRQYHQWLRQDO V\VWHP
$QDORJ VHUYR ,W PD\ FDXVH DEQRUPDO KHDW ¿UH DQG EXUQLQJ
WARNING
6%86 FRQQHFWRUV
Don't connect an S.BUS servo / gyro to
S.BUS2 connector.
38
Status
No signal reception
Receiving signals
Unrecoverable error (EEPROM, etc.)
,W GRHV QRW RSHUDWH
DANGER
Do not insert either a switch
or battery in this manner.