Hohphwu - FUTABA 6K Instruction Manual

(DFK WUDQVPLWWHU KDV DQ LQGLYLGXDOO\ DVVLJQHG XQLTXH ,' FRGH ,Q RUGHU WR VWDUW RSHUDWLRQ WKH
UHFHLYHU PXVW EH OLQNHG ZLWK WKH ,' FRGH RI WKH WUDQVPLWWHU ZLWK ZKLFK LW LV EHLQJ SDLUHG 2QFH WKH
OLQN LV PDGH WKH ,' FRGH LV VWRUHG LQ WKH UHFHLYHU DQG QR IXUWKHU OLQNLQJ LV QHFHVVDU\ XQOHVV WKH
UHFHLYHU LV WR EH XVHG ZLWK DQRWKHU WUDQVPLWWHU :KHQ \RX SXUFKDVH DGGLWLRQDO 56% UHFHLYHUV
this procedure is necessary; otherwise the receiver will not work.
/LQN SURFHGXUH
1. Place the transmitter and the receiver
close to each other within 20 inches(half
meter).
Less than 20 inches
2. Turn on the transmitter.
3. Select [MDL-SEL] and access the setup
screen shown below by press the jog key .
4. Use the jog key to select (NO LINK) or the
ID number next to LINK in the [MDL-SEL]
menu.
5. Hold down the jog key to enter the link
mode.
6. A chime from the transmitter notifies the
operator that the transmitter has entered
the link mode.
"Beep beep beep"
(Enters the link mode for 20 seconds)
In "Link" Mode
7. Immediately turn on the receiver power.
The receiver will enter the linking state
(LED blinks red) about 3 seconds after the
receiver power is turned on.
Receiver ON
8. If the receiver ID is displayed in the
transmitter and the LED changed from red
blinking to a steady green light, linking is
complete. (The receiver linking wait state
ends in about 3 seconds.)
9. Check system operation. If the transmitter
and receiver are not linked, try linking
again.
,I WKHUH DUH PDQ\ 7)+66 $LU V\VWHPV WXUQHG RQ LQ FORVH
SUR[LPLW\ \RXU UHFHLYHU PLJKW KDYH GLI¿FXOW\ HVWDEOLVKLQJ
a link to your transmitter. This is a rare occurrence.
+RZHYHU VKRXOG DQRWKHU 7)+66 $LU WUDQVPLWWHUUHFHLYHU
EH OLQNLQJ DW WKH VDPH WLPH \RXU UHFHLYHU FRXOG OLQN WR
the wrong transmitter. This is very dangerous if you do
QRW QRWLFH WKLV VLWXDWLRQ ,Q RUGHU WR DYRLG WKH SUREOHPZH
strongly recommend you to double check whether your
receiver is really under control by your transmitter.
:KHQ WKH OLQNHG WUDQVPLWWHU SRZHU LV WXUQHG RQ
communications begins.
:KHQ XVLQJ  UHFHLYHUV SHUIRUP WKH OLQNLQJ RSHUDWLRQ WKH
VDPH DV WKH VW UHFHLYHU +RZHYHU ZKHQ  UHFHLYHUV DUH
XVHG WKH WHOHPHWU\ V\VWHP FDQQRW EH XVHG
*Link is required when a new model is made from a model
selection.
WARNING
After the linking is done, please cycle receiver
power and check that the receiver to be linked
is really under the control of the transmitter.
Don't perform the linking procedure with
motor's main wire connected or with the
engine operating as it may result in serious
injury.
/LQN LV UHTXLUHG ZKHQ D QHZ
PRGHO LV PDGH IURP D PRGHO
VHOHFWLRQ
:KHQ WHOHPHWU\ FDQ W EH XVHG WU\
D UHOLQN RQFH DJDLQ
37