FUTABA 6K Instruction Manual page 70

（Changing the mixing reference point）
■ Mixing reference point setting
① Select the "OFFST" item and hold
the master side stick or knob in
the position you want to set and
set the new reference point by
pressing the Jog key.
Range：-100 ∼ +100%
（THR only 0 ∼ 100%）
CAUTION
At the end of setting, check that the mixing function is performed normally.
● Select the item with the
Jog key.
5Point curve
Function activation
Master CH select
Slave CH select
Switch selection
Switch ON direction
P.MIX4
Refer to the P.MIX1 ∼ 3 setting method described previously for settings other than the 5 point curve setting
described below.
■ 5point curve setting
① Select the setting item (P-1 ∼ P-5) of each point with the Jog key and set the amount of
movement of each point by pressing the + key or ‒ key.
CAUTION
At the end of setting, check that the mixing function is performed normally.
70
（1 second）
Default：0%
（P.MIX4 set up screen）
setting
Range：-100 ∼ +100%
（Including trim operation）
■ Trim ON/OFF setting
① S e l e c t t h e " T R M " i t e m
and select ON or OFF by
pressing the + key or ‒ key.
Range：OFF、ON
● When you do not want to include trim in
mixing select OFF.
Default：0%
＋
or
Default：OFF
● The set curve is displayed on a
graph.
● When INH is selected, the
function cannot be used.
When ON or OFF is selected,
the function is activated. ON
and OFF changes are linked
to the switch.
＋
or
−
−