FUTABA 6K Instruction Manual page 72

Servo monitor ／ Servo test
SERVO
Function
The servo display/servo test function displays the
CH1 to CH6 servo output bar graph and tests servo
operation.
7KH VHUYR GLVSOD\ IXQFWLRQ FDQ EH XVHG IRU D VLPSOH
RSHUDWLRQ FKHFN RI VXFK IXQFWLRQV DV WKH PL[LQJ
IXQFWLRQ
:KHQ WKH VHUYR WHVW IXQFWLRQ LV WXUQHG RQ WKH VHUYR
PRYHV WR WKH OHIW DQG ULJKW DW WKH VHW SHULRG $
Method
Calling the setting screen
① Call the menu screen from the
home screen by pressing the + key
for 1 second.
＋
(Servo Monitor）
● Select the setting item
with the Jog key.
(Servo Test）
Servo test ON/OFF
Channel Select
Servo test
■ Type/cycle/speed setting
① Select the setting item (TYPE, CYCL,
SPD) with the Jog key and set the item
by pressing the + key or ‒ key.
＋
（Range ／ Default）
TYPE：LNR, JMP ／ LNR
CYCL：1 ∼ 100 ／ 10（full speed at 1）
SPD：1 ∼ 100 ／ 7（full speed at 100）
72
② Select
from the menu with the Jog
key.
（1 second）
■ Channel selection
② Select the channel you want to
−
or
YDULDEOH VSHHG /15 OLQHDU PRGH RU À[HG VSHHG
-03 MXPS PRGH FDQ EH VHOHFWHG 7KLV FDQ EH
XVHG WR FKHFN WKH VHUYR HWF 2SHUDWLRQ 212))
FDQ DOVR EH VHOHFWHG IRU HDFK FKDQQHO
CAUTION
Using the servo test will move the servos to
WKHLU IXOO WKURZ 'R QRW XVH WKLV ZLWK OLQNDJHV
installed. Using it may damage the servo and
linkage.
"SERVO"
test with the Jog key and select
ACT/INH by pressing the + key
or ‒ key.
＋ −
or
Selection range：ACT, INH
Default：INH （only CH1 is ACT）
(Common)
③ Open the setting screen by
pressing the Jog key.
Switching to the servo test
screen
● Switch the screen by selecting
TEST and operating the jog
key to the left and right.
● The servo operating position
of each channel is displayed
on a bar graph.
Screen change
● Where "GRPH" is chosen, a
Jog key is pressed in right or
left.
Type Select
Cycle Select
Speed setting
● Operation of a servo test
■ Servo test start/stop
③ Select the "TEST" item
w i t h t h e J o g k e y a n d
start/stop the servo test
by pressing the + key or ‒
key.
＋ −
or
Selection range：ON, OFF
Default：OFF