FUTABA 6K Instruction Manual page 75

● Setting receiver voltage alarm.
Use this setting to sound an alarm when the receiver battery voltage drops dangerously low. VIB
(vibration) that vibrates the transmitter at the same time can also be set.
Method
Calling the setting screen
① Select "RX-BATT" from the telemetry
screen with the Jog key.
DN (down) shows than an
alarm is generated when
the voltage drops below
the set voltage.
Alarm set
① In the RX-BATT screen state, select
(ALARM) from the menu with the
Jog key.
Vibration set
① In the RX-BATT screen state, select
(VIB) from the menu with the Jog
key.
Alarm voltage set
① In the RX-BATT screen state, select
(LIMIT) 0.0V from the menu with
the Jog key.
② Open the setting screen by
pressing the Jog key.
② Select the "ACT" by pressing
the + key or ‒ key.
＋ −
or
② Select the "TYP1 ∼ TYP3" by
pressing the + key or ‒ key.
＋ −
or
② Select the voltage by pressing
the + key or ‒ key.
＋ −
or
"VIB" types
TYP 1
TYP 2
TYP 3
Selection range：
3.5V ∼ 8.4V
● When you want to set 5.0V, press the
+ key and ‒ key simultaneously.
75