FUTABA 6K Instruction Manual page 59

End point
E POINT
Function
The End Point function adjusts the
left and right servo throws, generates
differential throws, and will correct
improper linkage settings.
7KH VHUYR WUDYHO FDQ EH DGMXVWHG
LQGLYLGXDOO\ DW WKH OHIW DQG ULJKW
VLGHV
Method
Calling the setting screen
① Call the menu screen from the
home screen by pressing the + key
for 1 second.
＋
（1 second）
● Select the channel with
the Jog key.
＜ ChannelDisplay ＞
AIRPLANE (2AIL1FLP)
1: AI1（Aileron1）
2: ELE（Elevator）
3: THR（Throttle）
4: RUD（Rudder）
5: FLP（Flap）
6: AI6（Aileron6）
End point
① A channel is chosen by Jog key.
Selection range：1 ∼ 6ch
Adjust the rate of each direction of the stick and VR by repeating step ① .
0 ∼ 0 ∼
140% 140%
② Select
from the menu with the Jog
key.
（Left ／ Down） （Right ／ Up）
rate display rate display
HELICOPTER
1: AIL（Aileron）
2: ELE（Elevator）
3: THR（Throttle）
4: RUD（Rudder）
5: GYR（GYRO）
6: PIT（Pitch）
② Operate the stick or knob of the selected
channel fully to the left (down) or right (up)
and adjust the rate by pressing the + key or
‒ key.
＋
Servo throw
At 100% setting the servo throw of each channel is about 40°
for channels 1 to 4 and about 55° for channels 5 and 6.
However, the maximum servo travel for channels 5 and 6 is
about 110%.
*When channels 5 to 6 were mixed by 2 AIL etc, the throw
becomes the same (about 40° ) as channels 1 to 4.
"E POINT"
③ Open the setting screen by
Select the Left/Right (Down/Up)
with the stick (SW,VR).
GLIDER (2AIL2FLP)
1: AI1（Aileron1）
2: ELE（Elevator）
3: FL3（Flap3）
4: RUD（Rudder）
5: FL5（Flap5）
6: AI6（Aileron6）
−
or
(Common)
pressing the Jog key.
● T h e s e t t i n g r a t e o f e a c h
channel
MULTICOPTER
1: AIL（Aileron）
2: ELE（Elevator）
3: THR（Throttle）
4: RUD（Rudder）
5: AUX
6: MOD（Mode）
Range：
0 ∼ 140%
Default：100%
● When you want to
return the set value
to the initial value,
press the + key and ‒
key simultaneously.
59