FUTABA 6K Instruction Manual page 39

7KH 56% UHFHLYHU LV D YHU\ YHUVDWLOH XQLW ,W KDV  3:0 RXWSXWV DQG 6%86 RXWSXWV $GGLWLRQDOO\
WKH 6% RXWSXWV FDQ EH FKDQJHG IURP FKDQQHOV 3:0  FKDQQHO WR 6%86
+RZ WR FKDQJH WKH 56% &KDQQHO PRGH
6%86 ⇔ &+
7KH 56% LV FDSDEOH RI FKDQJLQJ LWV FKDQQHO
allocations as described in the table below.
1 Turn on the receiver. (At this moment, the
transmitter should be off.) Then, LED blinks
RED in about 3 seconds. Next, wait until it
becomes solid RED.
2 Press and hold the Mode switch more than 5
seconds.
3 Release the button when the LED blinks RED
and GREEN simultaneously.
4 The receiver is now in the "Operation CH Set"
mode. At this moment, the LED indicates
FXUUHQW VHW VWDWXV WKURXJK ÁDVKLQJ D SDWWHUQ
that corresponds to the CH mode.
56% &+ 0RGH WDEOH
6/SB
Red LED blink
*Cannot exit this CH setting mode before the operation mode is
¿[HG
6HH WKH EHORZ WDEOH WKDW VKRZV FRUUHVSRQGHQFH EHWZHHQ &+
PRGH DQG ZD\ RI ÀDVKLQJ /('
'HIDXOW &+ PRGH LV 0RGH $ &+ 
5 By pressing the Mode switch, the operation
6 The operation mode will be set by pressing
7 Release the button when the LED blinks
6 After confirming the operation CH mode is
7KH ³2SHUDWLRQ &+ 6HW´ PRGH FDQQRW EH FKDQJHG GXULQJ WKH
receiver communicates to the transmitter.
Mode A Mode B
6CH S.BUS
1 time 2 time
Default CH mode
PWM 6ch
CH is switched sequentially as " Mode A"
"Mode B" "Mode A"....
the Mode switch more than 2 seconds at the
desired CH mode.
RED and GREEN simultaneously. Then, the
RSHUDWLRQ &+ LV À[HG
changed, turn off and back on the receiver
power.
WARNING
6%86 FRQQHFWRUV
D o n ' t c o n n e c t s e r v o f o r
conventional system to S.BUS
port.
'LJLWDO VHUYR IRU FRQYHQWLRQDO V\VWHP
,W GRHV QRW RSHUDWH
$QDORJ VHUYR
KHDW ¿UH DQG EXUQLQJ
,W PD\ FDXVH DEQRUPDO
S.BUS
39