Emerson AMS Trex User Manual page 37

3.
4.
5.
Connect the Trex unit to a non-broadcasting wireless
network
You can connect to a wireless network that is non-broadcasting by manually entering
required options when in range.
Procedure
1.
2.
3.
4.
5.
6.
Enter a network address for an AMS Trex unit
You can specify how an AMS Trex unit connects to your network. Enter DHCP to allow a
network address to be assigned, or Static to specify an IP address and/or Subnet Mask.
Contact your network administrator before changing settings. Ensure the port you are
sending to is configured to receive AMS Trex data.
User Guide
Ensure the Wireless Networks option is set to ON.
The wireless communication is enabled.
Tap the network you want to connect to. You can tap to the right or left of the
network name.
Tap Connect, and enter credentials if prompted.
Once connected, a checkmark is displayed next to the name of the network to show
it is connected to the network. The wireless icon in the status bar changes to
Tap Settings or the status bar at the top of the screen.
Tap Wi-Fi.
Ensure the Wireless Networks option is set to ON.
This enables the wireless radio in the Trex unit.
Tap Add Wi-Fi Network....
Edit the following options as needed. You may need assistance from your network
administrator.
Option
Network SSID
Security
Tap Connect.
Depending on the network security, you may need to enter credential information
when the network is in range.
Description
The name of the wireless network.
The type of security used for the wireless network.
AMS Trex Device Communicator overview
.
29