Table of Contents
Advertisement
EVAL-AD7492SDZ User Guide
Drivers Setup Window 2 (Choose Install Location)
Figure 10.
EVAL-SDP-CB1Z
Figure 11.
EVAL-SDP-CB1Z
Figure 12.
EVAL-SDP-CB1Z
Figure 13.
EVAL-SDP-CB1Z
Drivers Setup Window 3 (Install)
Drivers Setup Window 4 (Finish)
Drivers Setup Window 5 (Restart)
After installation from the CD is complete, connect the
AD7492SDZ
to the
Evaluation Board Hardware section.
When the
EVAL-SDP-CB1Z
USB cable provided, allow the Found New Hardware Wizard
to run. Once the drivers are installed, verify that the board has
connected correctly by looking at the Device Manager of the
PC. Right-click My Computer/Manage/System Tools/Device
Manager, as shown in Figure 14, to find the Device Manager.
Analog Devices System Development Platform (32MB) should
appear under ADI Development Tools. This now completes
the installation.
LAUNCHING THE SOFTWARE
Once the
EVAL-AD7492SDZ
connected to the PC, the
To launch the software, complete the following steps:
1.
From the Start menu, select Programs/Analog Devices/
AD7492. The main window of the software then displays.
2.
If the
AD7492
USB port via the
launched, a connectivity error displays (see Figure 15).
Connect the evaluation board to the USB port of the PC,
wait a few seconds, click Rescan, and follow the instructions.
Rev. 0 | Page 9 of 24
EVAL-SDP-CB1Z
as described in the
board is first plugged in via the
Figure 14. Device Manager
and
EVAL-SDP-CB1Z
AD7492
software can be launched.
evaluation system is not connected to the
EVAL-SDP-CB1Z
when the software is
Figure 15. Connectivity Error Alert
UG-371
EVAL-
are correctly
Advertisement
Table of Contents
Need help?
Do you have a question about the EVAL-AD7492SDZ and is the answer not in the manual?
Questions and answers