JLG 800A Operation And Safety Manual page 32

SECTION 2 - USER RESPONSIBILITIES, MACHINE PREPARATION, AND INSPECTION
GENERAL
Begin the "Walk-Around Inspection" at Item 1, as noted on the dia-
gram. Continue to the right (counterclockwise viewed from top)
checking each item in sequence for the conditions listed in the fol-
lowing checklist.
TO AVOID POSSIBLE INJURY, BE SURE MACHINE POWER IS OFF.
DO NOT OPERATE MACHINE UNTIL ALL MALFUNCTIONS HAVE BEEN CORRECTED.
INSPECTION NOTE: On all components, make sure there are no loose
or missing parts, that they are securely fastened, and no visible dam-
age, leaks or excessive wear exists in addition to any other criteria
mentioned.
1. Platform Assembly - Platform Assembly and Gate -
Footswitch works properly, not modified, disabled or blocked.
Latch, stop, and hinges in working condition.
2. Platform Control Console -
neutral, decals/placards secure and legible, control markings
legible.
3. Rotator -
See Inspection Note.
2-8
Switches and levers return to
Figure 2-4. Daily Walk-Around Inspection (Sheet 2 of 4)
– JLG Lift –
4. Rotator Motion Control Valve -
5. Articulating Jib Boom -
6. Dual Capacity Limit Switch (ANSI, Australia, if
equipped); Transport Position Limit Switch (CE) - Prop-
erly secured, no damage to the switch, arm free to move,
and free from dirt and grease.
7. Power Track -
See Inspection Note.
8. Steer Cylinder Assembly -
Steer if equipped)
9. Spindle -
See Inspection Note.
10. Drive Motor and Brake -
11. Drive Hub -
See Inspection Note.
12. Wheel/Tire Assembly -
inflation (pneumatic). Inspect for worn tread, cuts, tears or
other discrepancies. Inspect wheels for damage and corro-
sion.
See Inspection Note.
See Inspection Note.
(4 Wheel
See Inspection Note.
(4 Wheel Steer if equipped)
See Inspection Note.
No loose or missing lug nuts, proper
3121209