JLG 800A Operation And Safety Manual page 34

SECTION 2 - USER RESPONSIBILITIES, MACHINE PREPARATION, AND INSPECTION
30. Engine Air Filter - No loose or missing parts; no visible
damage; element clean.
31. Battery - Proper electrolyte levels; cables tight, no visible
damage or corrosion.
32. Engine Oil Supply - Full mark on dipstick; filler cap secure.
33. Muffler and Exhaust System -
34. Hydraulic Pumps -
35. Engine Tray Pivot -
36. Hydraulic Swivel -
37. LP Gas Tank - Brackets, hose and fittings secure; no visible
damage, no missing parts. (If Equipped)
38. Flow Valves -
See Inspection Note.
2-10
See Inspection Note.
See Inspection Note.
See Inspection Note.
See Inspection Note.
Figure 2-6. Daily Walk-Around Inspection (Sheet 4 of 4)
39. Tower Boom - No visible damage; wear pads secure. All
cylinders - rod end pins and barrel-end pins properly
secured.
40. Frame -
See Inspection Note.
41. Main Boom Sections - No visible damage; wear pads
secure. All cylinders - rod end shafts and barrel-end shafts
properly secured.
42. Platform Pivot Pin -
43. Upright - In vertical position, relative to the chassis. Refer
to Figure 2-9. and Figure 2-10. If out of alignment, do not
use machine until the upright has been synchronized in
accordance with Section 4.16.
44. SkyGuard (If Equipped) -
– JLG Lift –
See Inspection Note.
.
See Inspection Note
3121209