Table of Contents
Advertisement
7 UTILITY PACKAGE (GX Configurator-CT)
7 - 10
(3) Menu bar
(a) File items
File operations are performed for the intelligent module parameters for the
project opened by GX Developer.
[Open file]
[Close file]
[Save file]
[Delete file]
[Exit]
(b) Online items
[Monitor/test]
[Read from PLC] : Reads the intelligent module parameters from the CPU
[Write to PLC]
POINT
(1) Saving the intelligent module parameter files
Since these files cannot be saved using the GX Developer's project save
operation, save the files using the intelligent module parameter setting
module selection screen mentioned above.
(2) Reading and writing the intelligent module parameters to and
from a PLC using GX Developer.
(a) Once the intelligent module parameters are saved in a file, they can be
read from and written to the PLC.
(b) Set the target PLC CPU using [Online]
Developer.
(c) When the QD62 (E/D) is mounted to the remote I/O station, use "Read
from PLC" and "Write to PLC" of GX Developer.
(3) Checking for the required utility
The head I/O is displayed in the Intelligent function module utility setting
screen, but a " " may be displayed for the model name.
This means that either the required utility is not installed or that the utility
cannot be started from the GX Developer.
Check for the required utility in [Tools] - [Intelligent function utility] - [Utility list...]
in GX Developer, and set it.
: Opens the parameter file.
: Closes the parameter file. If changes have been made,
the dialog box asking whether to save the file appears.
: Saves the parameter file.
: Deletes the parameter file.
: Ends the intelligent module parameter setting module
selection screen.
: Starts the select monitor/test module screen.
module.
: Writes the intelligent module parameters to the CPU
module.
MELSEC-Q
[Transfer setup] of GX
7 - 10
Advertisement
Table of Contents
