Siemens SINAMICS G110 Operating Instructions Manual page 41

04/2005
Table 3-3
Mode
TERMINAL
SERIAL
(USS-RS485)
SERIAL
(USS-RS232)
BOP
STARTER
Examples for Table 3-3:
The Analog variant can be operated in TERMINAL mode. This has been
described earlier in Section 3.3.1. The USS variant can also be operated in
TERMINAL mode. However, since no analog input is available, the frequency
setpoint has to be provided from one of the other modes.
The USS variant can be directly controlled using the SERIAL (USS-RS485)
mode. This mode is not supported on the Analog variant.
Note
Both variants will require
SERIAL (USS-RS232).
The hardware setup for SERIAL (USS-RS232) mode can also be used for
STARTER mode which additionally requires
SINAMICS G110 Operating Instructions
6SL3298-0AA11-0BP0
Modes of Operation Overview
Analog variant
(Requires switches
and potentiometer) supported, command
source can however be
via external switches)
Not supported
(USS-RS232 and USS-
RS485 cannot be used
(
converter on terminals
(PC to Inverter Connection Kit) if operated in mode
USS Variant
(Required Optional Equipment)
(Analogue input not
simultaneously)
either with RS485
x8/x9 or with )
(STARTER software).
Commissioning
Legend
= BOP
= PC to Inverter Connection Kit
= STARTER software
= supported
41