Bdin Rail Mounting Kit - Siemens SINAMICS G110 Operating Instructions Manual

DIN Rail Mounting Kit
B
The DIN Rail Mounting Kit is an optional accessory for the SINAMICS G110
inverter. It must be ordered as a separate item using the following Order Numbers:
For FSA:
For FSB:
The kit consists of the following items:
1 x Metal base plate
6 - FSA, 8 - FSB x M4 screws (maximum torque 2.0 Nm [17.7 lbf.in])
2 x Saddle-clamps
1 - FSA, 2 - FSB x DIN Rail fixing bolt.
In order to fit the DIN Rail Kit to the inverter and mount the inverter onto a DIN rail,
the following procedure should be performed:
Note
The DIN Rail Mounting Kit procedure outlined below refers to Figure B-1 on
page 81.
The installation procedure outlined below is for guidance only. Full and detailed
installation instructions will be delivered with the actual DIN Rail Mounting Kit.
1. Fit the DIN Rail fixing bolt as shown in Step 1.
2. Ensure that the fixing bolt is seated correctly into the cutout guides as shown in
Step 2.
3. Using the 2 or 4 M4 screws, secure the inverter to the metal base place as
shown in Step 3.
4. Clip the top recess of the metal base plate onto the DIN rail as shown in Step 4
in the direction as indicated by the arrow labeled 1.
5. Push the front of the inverter to secure the inverter to the DIN rail as shown in
Step 4 in the direction as indicated by the arrow labeled 2.
6. Check to ensure that the inverter is secured correctly onto the DIN rail.
7. Prepare the cables and wiring for the inverter as shown in Step 5, ensuring that
the cable sheath has been removed to allow a good grounding when secured
by the saddle-clamps.
8. Using four M4 screws, secure the cables to the metal base plate as shown in
Step 5 utilizing the saddle-clamps.
Removal of Inverter from DIN Rail
The release mechanism for DIN Rail Mounting Kit is located near the bottom of the
metal base plate, just above the saddle-clamps (see Step 6 in Figure B-1).
To release the inverter from the DIN rail you will require one or two 6 mm (¼") flat-
bladed screwdriver.
To release the inverter from the DIN rail the following procedure should be
performed:
1. Ensure the inverter is powered down.
2. Grasp the front of the inverter.
3. Insert the screwdriver in the release mechanism and push the release
mechanism in a downward direction.
80
DIN Rail Mounting Kit
6SL3261-1BA00-0AA0.
6SL3261-1BB00-0AA0.
SINAMICS G110 Operating Instructions
6SL3298-0AA11-0BP0
04/2005