Command Sources (P0700) - Siemens SINAMICS G110 Operating Instructions Manual

Using the SINAMICS G110

4.2 Command Sources (P0700)

This parameter determines from which source the inverter receives the Start, Stop
and Reverse commands. The SINAMICS G110 has two default settings depending
on the inverter variant, see the Quick Commissioning Flowchart on page 48.
NOTES
The ramp times and ramp-smoothing functions also affect how the motor starts and
stops. For details of these functions, please refer to parameters P1120, P1121 and
P1130 in the Parameter List.
Starting the motor
Analog Variant
Default value:
Other settings:
USS Variant
Default value:
Other settings:
Stopping the motor
There are several ways to stop the motor (for OFF1 – OFF 3 see page 55):
NOTE
All OFF commands are active low.
Analog Variant
Default value:
♦ OFF1
♦ OFF2
♦ OFF3
Other settings:
USS Variant
Default value:
♦ OFF1
♦ OFF2
♦ OFF3
54
2 – Terminal 3 (DIN 0, high)
see P0701 to P0704 in the Parameter List
5 – Terminals 8 and 9 (RS485)
see P0701 to P0703 in the Parameter List
2 – Terminal 3 (DIN 0, low)
2 – Terminal 3 (DIN 0, low)
Off button on Basic Operator Panel, pressing the Off
button once long (two seconds) or twice
no standard setting
see P0700 to P0704 in the Parameter List
5 – Terminals 8 and 9 (RS485)
Control word 1 (r0054), bit 00
Off button on Basic Operator Panel, pressing the Off
button once long (two seconds) or twice; control word 1
(r0054), bit 01
Control word 2 (r0054), bit 02
SINAMICS G110 Operating Instructions
6SL3298-0AA11-0BP0
04/2005