Installing The Microphone - Tait TM9100 Installation Manual

2.9

Installing the Microphone

This section describes the radio's microphone connector and the information
required to connect the microphone and install the microphone clip.
Important
1.
Connecting the
Microphone
2.
3.
4.
Installing the
Figure 2.7
Warning!! Safe radio mounting
Microphone Clip
Important
Install the microphone clip in the most convenient location using the screws
provided. The microphone must be within reach of the user but in such a
position that the PTT (press-to-talk) key cannot be inadvertently activated
or jammed.
26 Installing the Radio
The microphone grommet must be installed whenever the
microphone is plugged into the microphone socket:
to prevent damage to the microphone socket when
there is movement of the microphone cord, and
to ensure that the control head is sealed against water,
dust and other environmental hazards.
Plug the microphone into the microphone socket.
Slide the grommet along the microphone cord and push two adjacent
corners of the grommet into the microphone socket cavity.
Squeeze the grommet and push the remaining corners into position.
Check that the grommet is seated correctly in the cavity.
Correct remote cable grommet seating
Mount the microphone where it will not interfere with:
the deployment of passenger airbags
the vehicle operator controls
the vehicle operator's view.
Only install the microphone clip provided. If a non-
standard microphone clip is used, the correct operation of
the microphone hookswitch cannot be guaranteed.
microphone
grommet
control head
TM9100 Installation Guide
© Tait Electronics Limited August 2005