Table of Contents
Advertisement
3.9
Installing the Microphone
This section describes the radio's microphone connector and the information
required to connect the microphone and install the microphone clip.
1.
Connecting the
Microphone
2.
3.
4.
Figure 3.7
Installing the
Microphone
Clip
Install the microphone clip in the most convenient location using the screws
provided. The microphone must be within reach of the user but in such a
position that the PTT (press-to-talk) key cannot be inadvertently activated
or jammed.
TM8100/TM8200 Installation Guide
© Tait Limited October 2012
Notice The microphone grommet must be installed whenever the
microphone is plugged into the microphone socket:
to prevent damage to the microphone socket when there is
■
movement of the microphone cord, and
to ensure that the control head is sealed against water, dust and
■
other environmental hazards
Plug the microphone into the microphone socket.
Slide the grommet along the microphone cord and push two adjacent
corners of the grommet into the microphone socket cavity.
Squeeze the grommet and push the remaining corners into position.
Check that the grommet is seated correctly in the cavity.
Correct remote cable grommet seating
Warning
Safe radio mounting! Mount the microphone where
it will not interfere with:
the deployment of passenger airbags
■
the vehicle operator controls
■
the vehicle operator's view
■
Notice Only install the microphone clip provided. If a non-standard
microphone clip is used, the correct operation of the microphone hook-
switch cannot be guaranteed.
microphone
grommet
control head
Installing the Radio
27
Advertisement
Table of Contents
