Page 1
User Manual Breeze Model: ™ BZ-102LX, BZ-102-LXH, BZ-102LX-AUTO, BZ-103LX, BZ-105LX, BZ-105LX-AUTO REV. 6/16/20 Please read and understand this manual completely before operating this machine. 13655 Stowe Dr. Poway, CA 92064 P: (858) 679-1191 F: (858) 726-6005 www.mytee.com...
Page 2
Congratulations on the purchase of your new Breeze™ Carpet Extractor. As technology continues to develop you can work confidently knowing that both Mytee Products and its employees are equally dedicated to developing with the industry and its advances. Like any other piece of machinery or technology, the Breeze™ also requires proper maintenance and care to keep the product working over extended use.
Table of Contents Important Safety Information At a Glance 1.1 - Technical Specifications 1.2 - Included with the Breeze™ 1.3 - Breeze™ Front View 1.4 - Breeze™ Rear View Machine Operation 2.1 - Powering the Breeze™ 2.2 - Connecting Hoses 2.3 - Filling the Solution Tank 2.4 - Switching On the Breeze™...
When and if calling Mytee for support, please have your plug. The plug must be plugged into an appropriate outlet Model and Serial Number available for faster assistance.
Page 5
Important Safety Information 3. Always unplug power cord from electrical outlet before attempting any adjustments or repairs. 4. Do not unplug by pulling on cord. To unplug, grasp the plug, not the cord. 5. Do not pull or carry by cord. Do not close a door on cord or pull cord around sharp edges or corners.
PROPRIETARY AND CONFIDENTIAL THE INFORMATION CONTAINED IN THIS SIZE DWG. NO. DRAWING IS THE SOLE PROPERTY OF H110V MYTEE PRODUCTS, INC. ANY REPRODUCTION IN PART OR AS A WHOLE FINISH WITHOUT THE WRITTEN PERMISSION OF MYTEE PRODUCTS, INC. IS SCALE: 1:1 SHEET 1 OF 1 PROHIBITED.
2 - Machine Operation 2.1 - Powering the 2.4 - Switching On the Breeze™ Components Breeze™ Units Without Heater (BZ-102LX, BZ-102LX-AUTO, BZ-105LX, BZ-105LX-AUTO) Connect power cords by lining up the female end After a cleaning tool is connected and the solution tank is of the cord with the male filled, switch on the vacuums and the pump in any order.
2 - Machine Operation 2.5 - Chemical Injection (BZ-105LX-AUTO 2.7 - After Use Only) Emptying the recovery tank: Place a bucket or Fill the included 5 qt. bottle with chemical concentrate of your choice. With a cleaning tool connected, switch on other appropriate recepta- the pump and pull the trigger on your tool to keep water cle under the recovery tank...
Flip the latches down and then lift up on the handle and the machine will open up. ♦ 3.2 - System Maintainer Weekly flushing of the solution system with Mytee® System Maintainer helps keep lines clean and prevents chemical build-up, improving pump life, performance and pressure.
4 - Troubleshooting 4.1 - Vacuum Troubleshooting 4.2 - Pump Troubleshooting Vacuum is not turning on. Pump runs but there is no spray. Possible Cause Solution Possible Causes Solutions Vacuum may not be getting Check for faulty connec- Tank is empty. Fill tank.
4 - Troubleshooting 4.3 - Heater Troubleshooting Heater has hard water Run Mytee System Maintainer™ (Part # 3601) buildup inside, leading to Heater is not heating water. lost efficiency. through the machine regularly in order to clear Possible Causes Solutions...