Evap System Test - Launch Creader V+ User Manual

LAUNCH
You can use [ ] [ ] button to select an item and press [
display as shown below:
Press [ ] to return to Diagnostic Menu.

4.2.8 EVAP System Test

The EVAP test function lets you initiate a leak test for the vehicle's EVAP system.
The Creader V+ does not perform the leak test, but signals to vehicle's on-board
computer to initiate the test. Before using the system test function, refer to the
vehicle's service repair manual to determine the procedures necessary to stop
the test.
Select [EVAP System Test] and press [
information about EVAP system. Some vehicle manufacturers do not allow
external devices to control vehicle system. If the car supports this function, it will
display as below:
Figure 4-18
Figure 4-19
], the screen will display the relative
20
Creader V+ User's Manual
], the screen will